8 channel video optical transceiver manufacturers fault <br> <br>
Troubleshooting:
1, check whether the equipment is normal power supply.
2. Check whether the corresponding channel video indicator on the receiver is lit.
A: If the indicator light is on (the light indicates that the channel already has a video signal output). Then check whether the video cable between the receiver and the terminal device such as the monitor or DVR is connected properly, and whether the video interface connection is loose or there is a false weld.
B: The video indicator on the receiving end is off. Check whether the corresponding channel video indicator on the front end is on. (It is recommended to re-power the optical receiver to ensure the synchronization of the video signal)
8-channel video optical transceiver manufacturer's parameters
Road video optical transceiver is a video optical transceiver. This optical transceiver transmission channel adopts a modular design and can flexibly configure the number of channels according to engineering application requirements. The maximum configuration channel capacity is 8 forward video signals and 1 reverse data signal. The video signal is compatible with full-standard video signals; each video channel uses 8bit/13.5MHz digital sampling technology. The data signal supports 485 (optional) standard, baud rate 0-115200kps.
The digital optical channel adopts Gigabit transmission platform, transmission light wavelength 1310nm/1550nm, single-mode laser (LD) signal, the standard configuration transmission distance is 20Km, and maximum relay transmission distance is 80Km (the optical module needs to be replaced).
The device has a power status indicator, an optical signal indicator, a video signal indicator, and a data status indicator. It can intuitively detect the working status of the device power, optical signals, video signals, and data signals.
SRTA Silicone Rubber Fiberglass Heat-resistant Winding Belt
Description:
SRFA Silicon Heat-resisting glass fiber Winding Belt is made of non-alkali glass fiber braided fabric with thick iron oxide red silicone coating.
Product Feature:
a) Can block molten iron splash effectively.
b) Can`t be damaged by high temperature and flame.
c) Fireproof, heat insulation, heat prevention.
d) Can work at 260 degrees high temperature environment continuously.
e) Can withstand 1090 degrees for 15~20 minutes.
f) Can work at 1650 degrees for 15~30 seconds.
g) Can protect the the worker from being burned by the high temperature pipeline.
h) Can save the cost of heat loss.
Application:
a) Widely used in soft hose, steam pipe, cables for high temperature protection.
b) Very suitable for wrapping the soft hose and cables.
Standard Size:
Part No. Width/mm Thickness/mm Length m/roll
SRTA-25 25 1.2 20
SRTA-50 50 2.0 20
SRTA-100 100 2.9 20
SRTA-150 150 3.5 20
SRTA-200 200 4.0 20
Product images:
Fire Tape/Belt
Fire Tape,Fire Duct Tape,Fire Door Tape,Fire Detection Tape
KEYUACE Materials Co., Ltd. , https://www.insulationtubing.com